if you replace the belts and bushing and still not working !!!.
some thing you has to do is:
*take the unit out the pool.
* fleap the unit over in a bench or table.
* remove the drive track locate in the pulley side.
*conet the unit to the power supply.
* when the power is ready in the unit, take and look if the mechanical sistem (pully and belts are moving fine.
*if the pulley move and belts too, you have to call the company because you have isue whit the drive motor.
*Aqua Products Phone: (800) 845-4856.
*Recuest for (rma) number and sent you unit for the ride repair.
*if you have any other question please contac me trust this page or my email. jcmbjuan@msn.com
Jul 19, 2009 Rating
T2 Repair Suggestion by: Anonymous
BE CAREFUL,THE WHEEL TUBES, I THINK GO ON ONE WAY WITH THAT REVERSE CLUTCH BUILT INTO THE MIDDLE OF THE 2 TUBES.
I WOULD CHECK THAT THE WHEEL TUBES AND BELTS ARE ON CORRECTLY.
ALSO THAT MACHINE WORKS BETTER WITH THE BLACK SIDE PLATE BUSHINGS.
ANY OF THESE CLEANERS WITH A STAINLESS STEEL ROD COMING THRU THE WHEEL TUBE NEEDS THE BLACK BLUSHINGS.
IF T2 IS STILL ACTING FUNNY AFTER THE ABOVE IS DONE THEN IT NEEDS A DRIVE MOTOR.
Question: Has the machine had this problem since the belt change?
